Chapter 8 Using your robot
Enable pin code
Highlight the check box. Press to toggle the setting.
Enable PIN code OFF
Enable PIN code ON
Press to accept the new setting.
From now on certain commands will require the PIN code to be entered before they can
be executed.
Change pin code
Allows you to change the pin code.
Enter the required numbers and press .
Geofence
A Geofence is a circular security zone in which the robot is allowed to operate. If the robot
moves out of this area, a security notification will be issued. The circular area is defined by its
center and a radius.
Note: This functionality is not fully supported in the current version.
The current location of the center point can be viewed in the
110).
To define and implement a security zone
1.
Move the robot to the required center of the security zone.
2.
Press
.
3.
Press use the arrow keys to highlight
Security
, then press .
4.
Press the arrow keys to highlight
Geofence
and press .
5.
Highlight
Define current position
.
The latitude and longitude of the current position are displayed.
6.
Use
to highlight
Enable Geofence
.
7.
Make sure this option is checked on. Use to toggle the setting.
Turfmow 1000 Technician's Manual
Version: Release 3.5
Last updated: 2018-12-20
113