Chapter 7 Installation
Distances between the peripheral wire and boundary of the area to be mowed
The peripheral wire is set within the boundary of the area to be mowed (field) as shown in
Figure 28: Components of an installation
(page 38).
The distance between the peripheral wire and the boundary of the area to be mowed depends
on the nature of the surfaces around the field.
Figure 43: Rough grass that does not need to be mowed.
Distance between rough grass
and the peripheral wire 320mm
Width of grass not mowed 0mm
Figure 44: Raised hard landscaping
Distance between raised hard
landscaping and the peripheral
wire 650mm
Width of grass not mowed
330mm
Figure 45: Hard landscaping level with grass
Distance between the hard
landscaping and the peripheral
wire 200mm
Width of grass not mowed 0mm
Figure 46: Lawn-level planting
Distance between lawn-level
planting and the peripheral wire
500mm
Width of grass not mowed
180mm
Note: The values given above apply if the value of the parameter
(page 128) is set to the default value of 0.2m.
Sites containing narrow straits
The handling of sites which contain a narrow strait require special consideration.
50 Turfmow 1000 Technician's Manual
Version: Release 3.5
Last updated: 2018-12-20
