3
2.2 Hose Outlet (Arm angle adjustment)
The hose outlet can be fitted in your desired position by rotating the
arm 36 degrees at a time. (Fig.8)
Choose the position where the hose is bent as little as possible.
1) Remove the lock head from one side using the provided tool (Torx
driver T25). (Fig.9)
2) Remove the other side of the lock head. (Fig.10)
3) Loosen the four screws a little (1/2 revolution). (Fig.11)
4) Find a desired angle by rotating the arm 36 degrees at a time.
(Fig.12)
5) Tighten the four screws securely in the desired position.
6) Attach the lock heads to both sides.
CAUTION
- Do not remove the four screws, just loosen them.
Fig.8
①
②
③
④
Fig.9
Fig.11
Fig.12
Fig.10
Do not loosen these
two screws.
Fig.7
Mounting rail
