5
Part No.
Description
Size
N831488
HR-3G10
Oil
3/8 × 10m
G3/8
680140
Male fitting
G3/8- R3/8
680140
Male fitting
G3/8- R3/8
684517
Male fitting
G3/8- G1/4
N831888
HR-3WH15
Warm Water
3/8 × 15m
G3/8
854671
HR-4A15
Air
1/2 × 15m
Rc1/2
N830889
HR-4W15
Water
1/2 × 15m
R1/2
686457
Socket
Rc1/2 - Rc1/2
N831689
HR-4G15
Oil
1/2 × 15m
G1/2
681785
Male fitting
G1/2 - R1/2
Product No. Description Model
Application
Hose Reel
889
N832888
HR-3C15
Grease
Supply Hose
Hose Size
Outlet
Fitting (accessory)
Hose Reel
888
3/8 × 15m
G3/8
3.1 Installation of Dispensing Tool
Attach the provided hose fitting to the hose end. Then, attach a dispensing tool such as a gun to the hose fitting.
(Refer to Table 2)
■
Table 2
3.2 Positioning of Hose-Stop
Pull out the hose to the proper length and latch it. Remove the
hose-stop from the hose and install it securely to the desired position.
(Fig.15)
CAUTION
- If the hose-stop is not properly attached to the hose, it
may move when it hits against the outlet.
3.3 Adjustment of Spring Tension
1) With the supply hose completed coiled, insert a square drive
(13mm) into the square hole in the spring hub. (Fig.16)
2) Holding the square drive tightly in your hand, remove the two
screws securing the spring hub by using the provided tool (Torx
driver T25).
3) To increase spring tension, turn the spring hub to the A direction
(counterclockwise).
To decrease spring tension, turn the spring hub to the B direction
(clockwise).
4) Secure the spring hub with the two screws, holding the square
drive tightly.
5) After adjustment, check that the required length of the hose can
be drawn out without stretching the spring to the limit.
CAUTION
- Wear safety gloves when adjusting spring tension. There is a risk of injury.
- Failure to use the right tool for the square hole in the spring hub may result in an unexpected injury.
- Once the two screws are removed, spring tension is applied to the square wrench. Hold the wrench
tightly during adjustment.
Fig.15
Fig.16