Pairing Input Channels
27
01V96i—Reference Manual
Input
Channels
■
Pairing Channels by Using the
[SEL] Buttons
1.
While pressing and holding down the [SEL]
button for one of the channels you wish to
pair, press the [SEL] button for the adjacent
channel. (The paired channel numbers
should be odd and even in this order).
2.
When the Pair Confirmation check box is on
(see page 109), the Channel Pairing window
appears.
3.
Move the cursor to the desired button in the
Channel Pairing window, then press [ENTER].
The following buttons are available in this window:
• CANCEL
Cancels the operation.
• CH x
➔
y
Copies the odd channel parameter values to the even
channel.
• CH y
➔
x
Copies the even channel parameter values to the odd
channel.
• RESET BOTH
Resets both channel parameters to the default settings
(same as when Channel memory #01 is recalled).
Move the cursor to the desired button, then press
[ENTER] to confirm the pair.
■
Pairing Input Channels Using the
Display
1.
Press the [PAIR/GROUP] button repeatedly
until the Pair/Grup | Input page appears.
The parameters on this page are described below:
1
PAIR MODE
Determines how channels are paired.
2
STEREO/MONO x2 buttons
These buttons turn pairs on or off.
2.
Move the cursor to the PAIR MODE parameter
field (
1
), then select the HORIZONTAL or
VERTICAL button.
The function of each mode is described below:
• HORIZONTAL
This button pairs adjacent odd-even channels (default).
• VERTICAL
This button pairs counterpart channels on Layer 1 and
Layer 2 that share the same physical fader (e.g., CH1 &
CH17, CH16 & CH32, etc.). This mode is useful when
you wish to use one fader to control both stereo channels.
When you switch the Pair Mode, the combinations of
channel numbers displayed on the page also change.
3.
Move the cursor to the desired channel’s
MONOx2 button (
2
), then press [ENTER].
The channels are paired.
Note:
You can pair only channels that are adjacent, odd-even
(in this order) channels. Pressing the [SEL] button for a
non-adjacent channel will be ignored. You cannot create or
cancel a pair of vertical partners.
Tip:
Pressing and holding down the first [SEL] button of the
paired channels and pressing the second [SEL] button cancels
the pair.
Note:
•
When Pair mode is switched, only the channel numbers
change. The mix parameters of the paired partners do not
change.
•
For example, if you change Pair mode from Horizontal to
Vertical, the Input Channel “2” indication changes to
Input Channel “17.” However, its parameters do not
change. (If Channels 1 and 2 have been paired, switching
the mode will pair Channels 1 and 17.)
2
1
