Setting Preferences
231
02R96 Version 2—Owner’s Manual
Recall Confirmation:
When this preference is on, a confirmation message appears when
you recall a Scene (page 164) or library memory (page 143).
Patch Confirmation:
When this preference is on, a confirmation message appears when
you edit the Input and Output Patches (see page 66).
Pair Confirmation:
When this preference is on, a confirmation message appears when
you pair channels using the [SEL] buttons.
Nominal Pan:
When this preference is on, left/odd and right/even signals will be at nom-
inal level when Input Channel, or Bus to Stereo signals are panned hard left or hard right,
and at –3 dB when panned center. When this preference is off, signals panned hard left or
hard right will be at 3 dB, and at nominal level when panned center. In Surround mode, this
preference setting is used for the signal of any Surround Pan channel that is fully panned.
Fast Meter Fall Time:
When this preference is on, the level meters fall quicker.
TC Drop Warning:
When this preference is on, a warning message appears if a dropout
is detected in the incoming timecode.
DIO Warning:
When this preference is on, a warning message appears if any errors are
detected in digital audio signals received by the Slot Inputs or 2TR Digital Inputs.
MIDI Warning:
When this preference is on, a warning message appears if any errors are
detected in the incoming MIDI messages.
Initial Data Nominal:
When this preference is on, Input Channel faders are set to nom-
inal when Scene #0 is recalled.
Meter Follow Layer:
When this preference is on, the optional MB02R96 Peak Meter
Bridge automatically follows the Layer selection on the 02R96.
Scene MEM Auto Update:
When this preference is on, the Shadow Scene memories
Joystick Auto Grab:
When this preference is on, the Joystick automatically kicks in as the
surround pan control when it’s moved to the current surround pan position (see page 88).
Cascade COMM Link:
When this preference is on, various functions are linked between
cascaded 02R96s (see page 63). When this preference is off, only digital audio signals are
distributed among the cascaded 02R96s.
Solo Bus to Studio Out:
When this preference is on and all STUDIO buttons ([CON-
TROL ROOM], [STEREO], [AUX 7], [AUX 8]) in the MONITOR section are turned off,
soloed Input Channel signals are output via the STUDIO MONITOR OUT.
Auto Direct Out On:
When this preference is on and you change the channel Direct Out
destination from “–” to any other output, the channel Direct Out is automatically enabled.
If you change the channel Direct Out destination from an output to “–,” the channel Direct
Out is automatically disabled.
Routing ST Pair Link:
When this preference is on, routing from paired channels to the
Stereo Bus is linked.
