Grouping Input Channel Compressors
77
02R96 Version 2—Owner’s Manual
Grouping Input Channel Compressors
Input Channel Compressors can be grouped, allowing you to control the compression of
several Input Channels simultaneously by operating any Compressor control in the group.
There are four Input Channel Compressor groups: i, j, k, and l.
1
Use the DISPLAY ACCESS [GROUP] button to locate the Input Comp Link
page.
2
Use the LAYER buttons to select the Layers.
The corresponding group row is selected as each Layer is selected.
3
Use the Up/Down cursor buttons to select Comp groups i–l.
The selected group is highlighted by a flashing cursor box.
4
Use the [SEL] buttons to add and remove Input Channels to and from the
selected group.
The Compressor settings of the first Input Channel added to the group are applied to all
subsequently added Input Channels.
When an Input Channel is added to a group, its [SEL] button indicator lights up.
Delaying Input Channels
Each Input Channel features a Delay function. See “Delaying Channel Signals” on page 120
for more information.
Muting Input Channels (ON/OFF)
Input Channels can be muted as follows.
1
Use the LAYER buttons to select the Layers.
2
Use the [ON] buttons to mute the Input Channels.
The [ON] button indicators of channels that are on are lit.
ON
