LIGHTING SYSTEM
ELEC
+i
EAS00788
CHECKING THE LIGHTING SYSTEM
1 . The headlight and the high beam indicator
light fail to come on.
1 . Headlight bulb and socket
•
Check the headlight bulb and socket for con-
tinuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”
•
Are the headlight bulb and socket OK?
YES
V
*
NO
Replace the headlight
bulb, socket or both.
2. High beam indicator light bulb and socket
•
Check the high beam indicator light bulb and
socket for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”
•
Are the high beam indicator light bulb and
socket OK?
YES
V
4
NO
Replace the high beam
indicator light bulb ,
socket or both.
3. Voltage
•
Connect the pocket tester (DC 20 V) to the
headlight and high beam indicator light cou-
plers as shown.
AWhen the dimmer switch is set to “ % ”
BWhen the dimmer switch is set to “ & ”
Headlight
Positive tester probe
2
Negative tester probe
yellow
1
or green
black/green
3
Headlight coupler
A
DC 20V
1
| G^L
- © +
1
| G^L
®
High beam indicator light
Positive tester probe
->
yellow
(4)
Negative tester probe
-»
black/green
Meter assembly coupler
DC20V
©
Fn
B
G/W 1 Br
B/G
Lg
G 1
1
©
n Ch Dg
•
Set the main switch to “ON”.
•
Start the engine.
•
Set the dimmer switch to
%0
” or
%0
”.
•
Measure the voltage (DC 12 V) of
yellow
©
(green
(2)
) on the headlight coupler
and y e l l o w
©
on the meter assembly
coupler(wire harness side).
•
Is the voltage within specification?
Y
8-30
Downloaded
from
www.ScooterTime.net
