FRONT FORK
® <?
y
\J$^
(gfm;
^ ®
\ ^
EAS00658
ASSEMBLING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
NOTE:
8 When assembling the front fork leg, be sure
to replace the following parts:
- oil seal
- dust seal
8 Before assembling the front fork leg, make
sure all of the components are clean.
1. Install:
8damper rod assembly
1
8rebound spring
2
c
C
Allow the damper rod assembly to slide
slowly down the inner t u b e
3
until it
protrudes from the bottom of the inner tube.
Be careful not to damage the inner tube.
2. Lubricate:
8inner tube’s outer surface
Recommended lubricant
Fork oil 10W or equivalent
3. Tighten:
8 Copper washer
New
8 damper rod assembly bolt
(T)
X I
23 Nm (2.3 m
*
kg, 16.6 ft
*
lb)
NOTE:
While holding the damper rod assembly with the
damper rod holder
2
and T-handle 3 , tighten
the damper rod assembly bolt.
Damper rod holder
90890-01294(YM-01300-1)
T-handle
90890-01326(YM-01326)
4-24
Downloaded
from
www.ScooterTime.net
