SIGNALING SYSTEM
EAS00794
TROUBLESHOOTING
•
Any of the following fail to light: turn sig-
nal light, brake light or an indicator light.
•
The horn fails to sound.
Check:
1 . main fuse
2. battery
3. main switch
4. wiring connections
(of the entire signaling system)
NOTE:
8 Before troubleshooting, remove the follow-
ing part(s):
1 . battery cover/front cover
2. side cover(left and right)
3. front fork upper cover
4. front fork cover(left and right)
5. leg shield1,2
6. footrest board
8 Troubleshoot with the following special
tool(s).
P*
Pocket tester
90890-03112
YU-03112-C
EAS00739
2. Battery
•
Check the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3.
II
Minimum open-circuit voltage
12.8 V or more at 20°C (68°F)
•
Is the battery OK?
V
YES
4
NO
•
Clean the battery ter-
minals.
•
Recharge or replace
the battery.
EAS00749
•
Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.
•
Is the main switch OK?
YES
V
4
NO
Replace the main
switch.
EAS00738
1 . Main fuse
•
Check the main fuse for continuity.
Refer to “CHECKING THE FUSE” in chap-
ter 3.
•
Is the fuse OK?
YES
V
*
NO
Replace the fuse.
EAS00795
4. Wiring
•
Check the entire signal system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
•
Is the signaling system’s wiring properly con-
nected and without defects?
YES
V
Check the condi-
tion of each of the
signaling system’s
circuits.
Refer to “CHECK-
ING THE SIG-
NALING SYS-
TEM”.
4
NO
Properly connect or re-
pair the signaling
system’s wiring.
8-35
3. Main switch
Downloaded
from
www.ScooterTime.net
