SIGNALING SYSTEM
ELEC
+i
EAS00799
3. The turn signal light, turn signal indicator light
or both fail to blink.
1 . Turn signal indicator light bulb and socket
•
Check the turn signal indicator light bulb and
socket for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”
•
Are the turn signal indicator light bulb and
socket OK?
YES
V
*
NO
Replace the turn signal
indicator light bulb,
socket or both.
2. Turn signal light bulb and socket
•
Check the turn signal light bulb and socket
for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”
•
Are the turn signal light bulb and socket OK?
YES
V
4
NO
Replace the turn signal
light bulb, socket or both.
4. Voltage
•
Connect the pocket tester (DC 20 V) to the
turn signal relay coupler (wire harness side)
as shown.
Positive tester probe
-»
brown
©
Negative tester probe
->
ground
•
Set the main switch to “ON”.
•
Measure the voltage (DC 12 V) on brown
©
at the turn signal relay coupler (wire har-
ness side).
•
Is the voltage within specification?
YES
V
I
NO
The wiring circuit from
the main switch to the
turn signal relay coupler
is faulty and must be re-
paired.
Refer to “CIRCUIT DIA-
GRAM”.
3. Turn signal switch
•
Check the turn signal switch for continuity.
Refer to “CHECKING THE SWITCHES”
•
Is the turn signal switch OK?
YES
V
*
NO
Replace the left handle-
bar switch.
8-38
Downloaded
from
www.ScooterTime.net
