2-28
CABLE ROUTING DIAGRAM
A.
Fasten the start switch lead to
the handlebar with the plastic
bands.
B.
Fasten the engine stop switch
lead and clutch switch lead to
the handlebar with the plastic
bands.
C.
Pass the brake hose through
the hose guides.
D.
Secure the coupler by inserting
it into the multi-function display
bracket.
E.
Pass the throttle cables, clutch
cable and hot starter cable be-
tween the upper bracket and
multi-function display bracket.
F.
Fasten the multi-function display
leads to the bracket. Cut off the
tie end.
G.
Secure the coupler by pushing it
into the hole in the multi-function
display bracket.
H.
Secure the wire harness clip by
pushing it into the hole in the
multi-function display bracket on
the inside.
I.
Fasten the main switch lead
(wire harness side) to the multi-
function display bracket. Locate
the clamp end facing toward the
lower side of the frame and cut
off the tie end.
J.
Pass the speed sensor lead
through the guide on the outside
of the front fork.
Summary of Contents for 2010 WR450FZ
