SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
10-7
EBS20086
SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
EBS30336
SELF-DIAGNOSTIC FUNCTION TABLE
EBS30337
COMMUNICATION ERROR WITH THE METER
EBS30338
DIAGNOSTIC CODE: SENSOR OPERATION TABLE
TIP
The diagnostic code numbers cannot be displayed on the multi-function meter. To display the diagnos-
tic code numbers, use the Yamaha diagnostic tool.
Fault code
No.
Item
12
Crankshaft position sensor: no normal signals are received from the crankshaft position sen-
sor.
13
Intake air pressure sensor: open or short circuit detected.
14
Intake air pressure sensor: hose system malfunction (clogged or detached hose).
15
Throttle position sensor: open or short circuit detected.
16
Throttle position sensor: stuck throttle position sensor is detected.
21
Coolant temperature sensor: open or short circuit detected.
22
Intake air temperature sensor: open or short circuit detected.
30
Latch up detected.
33
Ignition coil: open or short circuit detected in the primary lead of the ignition coil.
37
Component other than ISC (Idle Speed Control) unit is defective (ISC operating sound is
heard).
Defective ISC (Idle Speed Control) unit (ISC operating sound is not heard).
39
Fuel injector: open or short circuit detected.
41
Lean angle sensor: open or short circuit detected.
42
Speed sensor: no normal signals are received from the speed sensor.
43
Fuel system voltage: incorrect voltage supplied to the fuel injector and fuel pump.
44
EEPROM fault code number: an error is detected while reading or writing on EEPROM.
46
Charging voltage is abnormal.
50
Faulty ECU (Engine Control Unit) memory. (When this malfunction is detected in the ECU, the
fault code number might not appear.)
Fault code
No.
Item
Er-1
ECU (Engine Control Unit) internal malfunction (output signal error): signals cannot be trans-
mitted between the ECU and the multi-function meter.
Er-2
ECU (Engine Control Unit) internal malfunction (output signal error): no signals are received
from the ECU within the specified duration.
Er-3
ECU (Engine Control Unit) internal malfunction (output signal error): data from the ECU cannot
be received correctly.
Er-4
ECU (Engine Control Unit) internal malfunction (input signal error): non-registered data has
been received from the meter assembly.
Summary of Contents for 2016 Grizzly yf700gg
