– 13 –
SPEC
CABLE ROUTING
Ï
Fasten the battery breather hose to the rear
fender with the plastic clamp and then insert the
clamp into the hole in the rear fender.
Ì
Fasten the battery
+
lead and starter motor lead
to the rear fender with the plastic clamps.
Ó
Install the starter circuit cut-off relay onto the tab
with its terminal side facing down.
È
Route the throttle cable and rear brake cable
through the cable guide. Make sure that the
throttle cable is routed to the inside of the rear
brake cable.
Ô
Make sure that the grommet is installed with the
mark facing forward.
Route the taillight lead through the lead holders
on the lid and the bottom of the box.
Ò
50 mm (2.0 in)
˜
5 mm (0.2 in)
