CVP-509/505/503/501 Reference Manual
5
V
oices – Pla
ying the K
e
yboard –
2
You can select the desired Harmony/Echo effect from a variety of types.
1
Press the [VOICE EFFECT] button.
2
Turn the Harmony/Echo on by pressing the [I] (HARMONY/ECHO) button.
3
Call up the operation display by pressing the [J] (TYPE SELECT) button.
4
Use the [1
▲▼
]–[3
▲▼
] buttons to select the Harmony/Echo type.
The Harmony/Echo types are divided into the following groups, depending on the particular effect
applied.
■
Harmony Types
When one of the Harmony Types is selected, the Harmony effect is applied to the note played in the right-
hand section of the keyboard according to the type selected above and the chord specified in the chord
section of the keyboard shown below.
Selecting the Harmony/Echo type
Harmony Types
These types apply the harmony effect to notes played in the right-hand sec-
tion of the keyboard according to the chord specified in the left-hand section
of the keyboard. (Note that the “1+5” and “Octave” settings are not affected
by the chord.)
Multi Assign Type
This type applies a special effect to chords played in the right-hand section
of the keyboard.
Echo Types
These types apply echo effects to notes played in the right-hand section of
the keyboard in time with the currently set tempo.
Split Point
(for the Voice)
LEFT Voice and chord section
for Harmony effect
RIGHT 1 and 2 Voices
Chord section for Style playback
and Harmony effect
Chord section for
Style playback and
Harmony effect
Split Point
Split Point
(for Style playback)
Split Point
LEFT Voice
RIGHT 1 and 2
Voices
