Yamaha Acoustic, Supplementary Manual

9

M.Band Dyna.

3-band dynamics processor, with individual solo and gain reduction metering for each band.

Dyna. Filter

Filter effect. The effect changes according to input level. 

Dyna. Flange

Flanger effect. The effect changes according to input level. 

Parameter

Display

Range

Description

Slope

SLOP

–6, –12 dB

Filter slope

Low Gain

LO.G

–96.0 to +12.0 dB

Low band level

Mid Gain

MI.G

–96.0 to +12.0 dB

Mid band level

High Gain

HI.G

–96.0 to +12.0 dB

High band level

Lookup

LKUP

0.0 to 100.0 ms

Lookup delay

Ceiling

CEIL

–6.0 to 0.0 dB, Off

Specifies the maximum output level

L–M Xover

L-MX

21.2 Hz to 8.00 kHz

Low/mid crossover frequency

M–H Xover

M-HX

21.2 Hz to 8.00 kHz

Mid/high crossover frequency

Presence

PRE

–10 to +10

For positive values, the threshold of the high band is lowered and the 
threshold of the low band is increased. For negative values, the oppo-
site will occur. When set to 0, all three bands are affected the same.

Comp. Bypass

COMP

Off, On

Compressor bypass

Comp. Threshold

CMPT

–24.0 to 0.0 dB

Compressor threshold

Comp. Ratio

CRAT

1:1 to 20:1

Compressor ratio

Comp. Attack

CATA

0 to 120 ms

Compressor attack

Comp. Release

CREL

6 to 11500 ms

Compressor release time

Comp. Knee

CKNE

0 to 5

Adjusts the width of the gain curve just above the compressor‘s thresh-
old

Exp. Bypass

EXP

Off, On

Expander bypass

Exp. Threshold

EXPT

–54.0 to –24.0 dB

Expander threshold

Exp. Ratio

ERAT

1:1 to 

∞

:1

Expander ratio

Exp. Release

EREL

6 to 11500 ms

Expander release time

Lim. Bypass

LIM

Off, On

Limiter bypass

Lim. Threshold

LIMT

–12.0 to 0.0 dB

Limiter threshold

Lim. Attack

LATA

0 to 120 ms

Limiter attack

Lim. Release

LREL

6 to 11500 ms

Limiter release time

Lim. Knee

LKNE

0 to 5

Adjusts the width of the gain curve just above the limiter‘s threshold

Parameter

Display

Range

Description

Type

TYPE

Low Pass Filter, High Pass Filter, 
Band Pass Filter

Filter type

Decay

DCY

6 to 46000 ms

Filter frequency change decay speed

Direction

DIR

Up, Down

Upward or downward frequency change

Sense

SENS

0 to 100

Sensitivity

Offset

OFST

0 to 100

Filter frequency offset

Resonance

RESO

0 to 20

Filter resonance

Level

LVL

0 to 100

Output level

Mix

MIX

0 to 100%

Mix level

Parameter

Display

Range

Description

Decay

DCY

6 to 46000 ms

Decay speed

FB. Gain

FB

–99 to +99%

Feedback gain (plus values for normal-phase feedback, minus values for 
reverse-phase feedback)

Direction

DIR

Up, Down

Upward or downward frequency change

Sense

SENS

0 to 100

Sensitivity

Offset

OFST

0 to 100

Delay time offset

LSH Freq.

LSHF

21.2 Hz to 8.00 kHz

Low shelving filter frequency

LSH Gain

LSHG

–12.0 to +12.0 dB

Low shelving filter gain

EQ Freq.

EQ.F

100 Hz to 8.00 kHz

EQ (peaking type) frequency

EQ Gain

EQ.G

–12.0 to +12.0 dB

EQ (peaking type) gain

EQ Q

EQ.Q

10.0 to 0.10

EQ (peaking type) bandwidth

HSH Freq.

HSHF

50.0 Hz to 16.0 kHz

High shelving filter frequency

HSH Gain

HSHG

–12.0 to +12.0 dB

High shelving filter gain

Mix

MIX

0 to 100%

Mix level