The jumper settings
of the drive should
be master or factory
default.
Be careful not to
damage any cables
or components and
double check the
connection between
the cables, the
bridge board and
your drive before
you close up the
case.
Drive Assembly
Connect the ATA cable and the power line to your drive. Install
the drive and fasten the four screws as shown below. Align the
top cover with the body and fasten the screws on both front
and back. Use the included stickers to cover the front screws
and then connect your power adapter and interface cable.
Copyright © 2000-2004 by Macpower Peripherals Ltd. - www.macpower.com.tw
- 4 -
