Pre-operation checks
89
Drain plug check
Loosen the drain plugs and remove them, and
then make sure that the plugs and the O-rings
on the hull drain plugs are not damaged and
that there is no foreign material on the threads
or the O-rings on the hull drain plugs.
NOTICE:
Before installing the drain plugs,
clean the drain plug threads and the
O-rings on the hull drain plugs to remove
any foreign materials, such as dirt or sand.
Otherwise, the drain plugs could be dam-
aged, allowing water to enter the engine
compartment or the fuel tank compart-
ment. Make sure that the drain plugs are
tightened securely before launching the
boat. Otherwise, water may flood the boat
and cause it to submerge.
Securely install the drain plugs by tightening
them until they stop.
1
Hull drain plug
1
Engine compartment drain plug
1
Fuel tank compartment drain plug
1
1
1
1
SportsBoat_F4B10.book Page 89 Thursday, June 2, 2016 10:08 AM
Downloaded from
