Using surround speakers (MusicCast
Surround function)
Devices that support the MusicCast Surround function and serve as
“Pairing Devices”, such as the MusicCast 20, can be used as
surround speakers with this unit.
Left surround
speaker
Right surround
speaker
1
Use the MusicCast CONTROLLER app to register
the unit and devices that support the MusicCast
Surround function (Pairing Devices) with the same
location.
2
Follow the app’s on-screen instructions to set up
the MusicCast Surround function.
NOTE
▪ This function will be made available through a future firmware update. For details,
refer to the website for this product.
▪ Functions and installation may vary depending upon the devices that support the
MusicCast Surround function (Pairing Devices) used. For details, see
documentation supplied with the device.
Enabling/disabling the network standby
function
Enabling the network standby function allows the unit to be turned
on or off using a mobile or Bluetooth device as follows.
This function is enabled by default.
• When the unit is turned off, it will turn on with the following
playback operations.
– Music files are played using the AirPlay function.
– Music files stored on a network attached storage (NAS) unit are
played
• The unit can also be turned on and off using the MusicCast
CONTROLLER app installed on your mobile device.
• When a Bluetooth device is connected to this unit while it is off,
this unit turns on and the input source switched to BLUETOOTH.
1
Turn off the unit.
En
46
