21
English
REMO
TE CONTR
OL
APPENDIX
PREP
ARA
TION
OPERA
TION
MENU FUNCTIONS
INPUT
selector button
The Auto Power function may not function properly
depending on the signal output level of connected
component. In this case, you can refer to the table given
below to change the sensitivity of the Auto Power function.
Pr will cycle through the selections from top to
bottom, while pressing – will cycle through the selections
from bottom to top.
Display
Setting/Symptom
OFF
Do not use the Auto Power function.
1
When Auto Power On does not function even though
a signal arrives or when Auto Power Off results even
though there is a continuing signal.
2
Ordinary setting when using the Auto Power
function.
3
When Auto Power On results even though no signal
has arrived, or when Auto Power Off does not result
even though there is no current signal.
To cancel the menu functions, press MENU until the input
display returns.
Adjusting Display Brightness
The display brightness of the front speaker unit can be
adjusted as follows.
1
Press MENU to display “Dimmer”.
The currently brightness level (such as “Dimmer: ±0”)
will be displayed.
2
Press MENU + or – to adjust the brightness.
Pr will brighten the display, while pressing –
will dim the display. Brightness can be adjusted from
–3 (dimmest) to +3 (brightest).
To cancel the menu functions, press MENU until the input
display returns.
The menu functions include: “Auto Power” for setting
automatic power on/off, “Dimmer” for adjusting display
brightness, “Input Name” for naming input, and “Delay
Time” for adjusting the delay time used for surround sound.
Adjustments on the menu functions should be performed
with the remote control.
Each time MENU on the remote control is pressed, the
function displayed will cycle in the order: “Auto Power”,
“Dimmer”, “Input Name”, “Delay Time” (only appears
when the selected DSP program is DOLBY DIGITAL/
DOLBY PRO LOGIC, or DOLBY DIGITAL ENHANCED/
DOLBY PRO LOGIC ENHANCED), and input display.
MENU +/–
MENU
Setting Auto Power On/Off
Auto Power functions as described below.
1. No input signal and no buttons have been operated for
30 minutes.
2. Auto Power Off automatically shuts off the power. (The
STANDBY indicator will slowly flash.)
3. If a signal is input, Auto Power On automatically turns
the power on. (Or power can be turned on again using
p
on the remote control.)
You can set sensitivity for the Auto Power function or turn
the Auto Power function off completely.
1
Press MENU to display “Auto Power”.
2
To set Auto Power On, use the MENU + or – to
select the “Auto Power 2”. To set Auto Power
Off, use the MENU – to select the “OFF”.
0104AV-S70_17-22_EN
3/29/0, 4:31 PM
21
