English
REMO
TE CONTR
OL
APPENDIX
PREP
ARA
TION
OPERA
TION
E-
7
INSTALLATION
Installing the Front Speaker Unit
To prevent the front speaker unit from falling, secure it with the provided fastener when placing it on a television or other
device. Also, use the height adjustment bracket on the rear of the front speaker unit when there is a step on the installation
surface.
■
Using the fasteners
Precautions before installation
•
Do not touch the adhesive surface after peeling off the strip as this will weaken its adhesive strength.
•
Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the
surface is dusty, oily or wet and that this may cause the front speaker unit to fall.
1
Peel off the seal of the fastener with the rough
surface and apply to the protrusions on the
bottom of the front speaker unit.
Note
• Once the front speaker unit is secured in this way, the paint on the
television surface used for installation may peel off when fastener
is removed later. Be sure to apply fasteners after carefully
checking the surface you are going to use for installation.
Press down.
4
Align the fasteners on both sides and firmly
press downward from the top of the front
speaker unit.
Smooth surface
Peel off the seal.
3
Peel off the seal of the fastener with the
smooth surface and apply to the positions
determined in step 2.
2
Place the front speaker unit where it is to be
installed (ex. on top of the television ) to
determine where to apply the fastener with the
smooth surface.
Protrusion
Front speaker
(bottom panel)
Rough surface
Wrap the fastener tightly
with sides of the tape well
aligned with the edges of
the protrusion.
Position it so that the fastener stuck to the front
speaker unit matches that of the fastener stuck to
the top of the television.