34
En
SETUP menu
■
General Setting
The default settings are marked with “
*
”.
System
Auto Power Standby
Sets the power-saving function to on/off.
When set to on, this Player will turn to standby mode after
20 minutes from the last operation without any playback.
– Before this Player turns to standby mode, the screen
saver (p. 38) will activate.
On
*
, Off
HDMI Control
You can set the Player to receive control signal from a
TV/AV receiver compatible with the HDMI Control
function via an HDMI cable (p. 12).
On, Off
*
Using HDMI Control function
Using the HDMI Control function, you can interactively
operate this Player with your TV (HDMI Control
function supported).
When you connect this Player to the TV compatible with
the HDMI Control function using an HDMI cable and
set HDMI Control in the SETUP menu to on (p. 34), you
can perform the function listed below.
•Automatic input select function
When you start playback of this Player, the input
selector of the TV (and an AV receiver if this Player is
connected to the TV via the AV receiver) is switched
to this Player automatically. TV Power is turned on
automatically depending on the TV.
•Automatic power off function
When you turn off the TV while this Player is in stop
mode and the SETUP menu screen is not displayed, the
power of this Player is also turned off automatically.
– HDMI Control function may not work properly
depending on the TV.
– Functions other than ones shown above may work
depending on the TV or AV receiver.
– In order to make the HDMI Control function
available, set up settings for the HDMI Control
function on ALL components (this Player, TV,
and AV receiver). Certain operation may also be
required.
– Each function may be set independently to
activate/deactivate depending on the TV.
– Refer to the operation manuals supplied with the
TV and/or AV receiver for details regarding setup.
– When set to on, power consumption during
standby mode increases due to HDMI Control
function.
Load Default
You can reset all settings of this Player to default setting
except Security setting (p. 35). For details on default
settings, see pages 31-39.
Upgrade
You can upgrade the software manually from USB
Storage or Network. For details on software upgrade, refer
to “Software upgrade” (p. 42).
Upgrade Notification
You can select whether to display the message on the
screen when this Player detects newer software over the
Internet.
On
*
, Off
3D Playback Message
You can turn on or off a warning message concerning 3D
video playback that appears on the TV when this Player is
turned on.
On
*
, Off
Local Storage
You can check the free space of USB memory device
connected to this Player, or format (empty) the “BUDA”
folder in the USB memory device connected to this Player
by selecting Format.
– To enjoy the BD-Live feature (p. 30), you need to
connect a USB memory device (with at least 2GB of
free space) to one of the USB connectors (front/rear)
of this Player to use the USB memory device as
Local Storage.
Easy Setup
You can perform Easy Setup (p. 19).
Software License
You can view the information about third party software
license.
By using this product, you will be deemed to have
accepted the terms and conditions.
Hint
Notes
Hint
