233
Other functions
14
Operation section
The settings of the Pan MONI page will be as fol-
lows.
7
Press the RECORDER [9-16] key to select
monitor channels 9–16 as the mixing layer,
and set faders 7/8 (monitor channels 15/
16) and the STEREO fader to the 0 dB posi-
tion.
8
Press the [METER] key to display the METER
screen.
The METER screen will appear, displaying meters
for the input/output levels of tracks 1–16.
The METER screen contains a Meter 1 page and a
Meter 2 page, but in this example you may select
either page.
9
Move the cursor to the INPUT MONITOR
area in the lower left of the display, and
turn on the INDI. button. At this time, ver-
ify that the INPUT buttons are highlighted
for the record-ready tracks 15/16.
If the INDI. (individual) button is on, you will
always be able to monitor the input signal for
tracks whose INPUT button is highlighted as
“
,” regardless of the current running mode.
Tip!
For details on the function of each button in the
INPUT MONITOR area, refer to page 352.
■
Create a mix and record
10
Press the PLAY [
] button to play back the
song.
11
Press the RECORDER [1-8]/[9-16] keys to
select monitor channels 1–8/9–16 as the
mixing layer, and create the mix balance
for tracks 1–14.
While you create the mix, make sure that the
input level does not clip for tracks 15/16 in the
METER screen.
If you want to adjust monitor channel 1–14
parameters other than the faders (e.g., pan, EQ,
dynamics processor), you will need to use the
[PAN], [EQ], and [DYN] etc. to access other
screens. After adjusting pan or EQ, be sure to
return to the METER screen to check the input
levels, and adjust the faders as necessary.
12
When you have finished creating the mix,
hold down the REC [ ] key and press the
PLAY [
] key to begin recording on tracks
15/16.
Tip!
When you have finished ping-pong recording on
tracks 15/16, you can switch the virtual tracks of
tracks 1–14, and record other instruments on tracks
1–14 without losing the original source tracks of the
ping-pong recording.
