256
Reference section
SETUP screen
D.in Setup page
Word clock and cascade settings
In this page you can select the word
clock source to which the AW2816 will
synchronize, and make vari-pitch set-
tings. You can also make settings for
cascading the digital output of an exter-
nal device into the stereo bus of the
AW2816.
• [SETUP] key
→
[F1] (D.in Setup) key
• Repeatedly press the [SETUP] key
until the screen shown at the right
appears.
A
Slot
If an optional I/O card is installed in OPTION I/O
slot, a graphic will be displayed to show the type
of I/O card. Cards in which no card is installed
will be displayed as “No Card.”
B
WORD CLOCK SOURCE
From the following choices, select one of the fol-
lowing clock source to which the AW2816 will
synchronize.
• SLOT 1/2–7/8
The input signal from a digital I/O card installed in
OPTION I/O slot will be the clock source. One
pair of digital I/O card input channels 1/2–7/8 can
be selected.
Choose this setting when you want to use an exter-
nal device such as a digital MTR as the word clock
master, so that the AW2816 will synchronize to
the clock data included in the digital input signal.
• INT
The internal clock of the AW2816 will be selected
as the clock source.
Choose this setting when you are using the
AW2816 by itself, or when you want to use the
AW2816 as the word clock master to which a dig-
ital MTR or other external device will synchronize.
• D.ST IN
The word clock data included in the input signal
of the DIGITAL STEREO IN jack will be the clock
source.
Choose this setting when cascading the digital out-
put of an external device into the stereo bus of the
AW2816, or when you are inputting the signal of a
device that cannot act as a slave (e.g., a CD player)
via the DIGITAL STEREO IN jack.
A highlighted button indicates that it is
currently selected as the word clock
source.
A button with an X mark indicates that
no digital audio signal is being input
from the corresponding digital I/O card
or connector. A button that is displayed
in this way cannot be selected as a clock
source.
A button with a/mark indicates that a
digital audio source is being input from
the corresponding digital I/O card or
connector, but is not synchronized with
the internal clock of the AW2816.
This indicates that digital audio is being
input from the corresponding digital I/O
card or connector, and is synchronized
with the internal clock of the AW2816.
4
3
1
5
2
