SYSTEM OPERATIONS
12
En
Follow the procedure below to select an input source and adjust the sound settings on the system.
1
Press ON/STANDBY, OFF on the front panel
of the receiver and the CD player.
2
Press
(standby/on) to turn on the
receiver.
Depending on the input mode of the receiver, the CD
player also turns on by the system control connection
(see page 9). The front panel display lights up.
3
Press one of the input selection keys (or
rotate INPUT on the front panel) to select the
desired input source.
4
Start playback on the selected source
component or select a radio station.
For information on the disc/USB device playback,
see page 14, and for information on tuning, see
page 17.
5
Press VOL +/– (or rotate VOLUME on the
front panel) to adjust the volume to the
desired output level.
■
To adjust the audio quality
1
Press TONE/BALANCE to select BASS,
TREBLE, or BALANCE.
2
To adjust the setting, press
or
.
BASS:
Adjusts the low frequency response.
TREBLE:
Adjusts the high frequency response.
BALANCE:
Adjusts the volume level of each left
and right speaker channel.
■
Pure Direct mode
The Pure Direct mode shuts down the tone control
circuitry and front panel display, allowing you to enjoy
pure high-fidelity sounds.
Press PURE DIRECT (or PURE DIRECT on the
front panel) to turn on the Pure Direct mode.
The PURE DIRECT indicator lights up, and the front
panel display goes off.
• If you carry out operations while the Pure Direct mode is turned
on, the front panel display lights up briefly to acknowledge the
command.
• While the Pure Direct mode is turned on, neither BASS,
TREBLE, nor BALANCE is available.
To turn off the Pure Direct mode
Press PURE DIRECT again so that PURE DIRECT
indicator turns off and the front panel display lights up.
■
Muting the sound (MUTE)
Press MUTE to turn off the sound.
MUTE ON appears on the front panel display.
To restore the sound, press MUTE again or press VOL +/–.
SYSTEM OPERATIONS
Basic system operations
ON/STANDBY
OFF
PHONES
VOLUME
INPUT
PURE
DIRECT
TUNER PRESET
MIN
MAX
USB
ON/STANDBY
OFF
VOL
VOL
TONE BALANCE
DISPLAY
DIMMER
SLEEP
MUTE
PURE DIRECT
CD
iPod
FM/AM
PHONO
AUX
USB
PRESET
TUNING
(standby/on)
VOL +/–
INPUT
Input selection
keys
ON/STANDBY, OFF
VOLUME
PURE DIRECT
TONE/BALANCE
/
PURE DIRECT
MUTE
Notes