English
TROUBLESHOOTING
15
En
ADD
ITIONAL
INFO
RMA
T
IO
N
Audio Section
• Frequency response ..................................... 2 Hz - 20 kHz, ± 0.5 dB
• Harmonic dist noise (1 kHz)......................... 0.003 % or less
• S/N ratio.................................................................... 105 dB or more
• Dynamic range............................................................ 96 dB or more
• Output voltage (1 kHz, 0 dB) ...........................................2.0 ± 0.3 V
Laser Diode Properties
• Material..................................................................................GaAlAs
• Wavelength .............................................................................790 nm
• Laser Output ..............................................................max. 1.23
μ
W*
* This output is the value measured at a distance of about 200 mm
from the objective lens surface on the Optical Pick-up Block.
General
• Power requirements
U.S.A. and Canada models .............................. AC 120 V, 60 Hz
Australia model ................................................ AC 240 V, 50 Hz
Europe model ................................................... AC 230 V, 50 Hz
Asia and General models ...... AC 110-120/220-240 V, 50/60 Hz
• Operating temperature............... +5
°
C to +35
°
C (+41
°
F to +95
°
F)
• Power consumption................................................................... 16 W
• Standby power consumption ......................................less than 0.5 W
• Dimensions (W × H × D)................................. 435 × 116 × 405 mm
• Weight ...................................................................................... 6.2 kg
Please note that all specifications are subject to change
without notice.
iPod™
“iPod” is a trademark of Apple Inc., registered in U.S. and
other countries.
“Made for iPod” means that an electronic accessory has
been designed to connect specifically to iPod and has been
certified by the developer to meet Apple performance
standards.
Apple is not responsible for the operation of this device or
its compliance with safety and regulatory standards.
Sound “skips”.
This unit is being subjected to vibrations or
impacts.
Relocate this unit.
—
The disc is dirty.
Clean the disc.
Sound “hums”.
Improper cable connections.
Securely connect the audio cables. If the
problem persists, the cables may be defective.
Noise from a nearby
tuner.
The tuner is too close to this unit.
Move the tuner and this unit farther apart or turn
off this unit.
—
Noise from inside of
the disc tray.
The disc may be warped.
Replace the disc.
—
The remote control
does not work or
function properly.
Wrong distance or angle.
The remote control functions within a
maximum range of 6 m (20 ft) and no more than
30 degrees off-axis from the front panel.
Direct sunlight or lighting (from an inverter type
of fluorescent lamp, etc.) is striking the remote
control sensor of this unit.
Reposition this unit.
—
The batteries are weak.
Replace all batteries.
Problems
Possible Causes
Solutions
Refer to
page
SPECIFICATIONS
