TROUBLESHOOTING
27
En
Engl
ish
O
T
HERS
❚
Network
The remote control does not
work or function properly.
Wrong distance or angle.
The remote control functions
within a maximum range of 6 m
(20 ft) and no more than 30
degrees off-axis from the front
panel of the main unit.
Direct sunlight or lighting is
striking the remote control
sensor of this unit.
Adjust the lighting angle, or
reposition this unit.
—
The batteries are weak.
Replace both batteries with new
ones.
The amplifier control buttons on
the remote control do not work
on the amplifier.
Your amplifier is not one of
Yamaha amplifiers. (These
buttons may not work on some
Yamaha amplifiers.)
Use the remote control of your
amplifier.
—
Problem
Cause
Remedy
Page
The network feature does not
function.
The network parameters (IP
address) have not been obtained
properly.
Enable the DHCP server
function on the broadband
router and set “DHCP” in the
setup menu to “On” on this unit.
If you want to configure the
network parameters manually,
check that you are using an IP
address which is not used by
other network devices in your
network.
This unit does not detect the
digital media server (PC).
The media sharing setting is not
correct.
Configure the media sharing
setting of your PC.
Some security software installed
on your PC is blocking the
access of this unit to your PC.
Check the settings of security
software installed on your PC.
—
This unit and your PC are not in
the same network.
Check the network connections
and the broadband router
settings, then connect this unit
and your PC to the same
network.
Access to this unit is restricted
by MAC address filter function
Disable MAC address filter
function in the setup menu of
this unit.
There are more than two routers
in use that are overlapping
among the network devices.
Disconnect the Internet
connection temporarily and
check via your local network, or
connect the network devices
you want to use to the same
router.
—
Problem
Cause
Remedy
Page
