CDC-697
CDC-697
8
■
DISASSEMBLY PROCEDURES
Fig. 1
(Remove parts in the order as numbered.)
1.
Removal of Top Cover
a.
Remove 4 screws (
1
) and 3 screws (
2
). (Fig. 1)
b.
Lift the top cover at the rear and move it rearward
slantingly.
2.
Removal of Clamp Ass’y
a.
Remove 2 screws (
3
). (Fig. 1)
b.
Remove clamp ass’y. (Fig. 1)
3.
Removal of Tray Ass’y
a.
Remove 1 screw (
4
). (Fig. 1)
b.
Turn gear/L0. (Fig. 2) Counter clockwise gradually
until immediately before the tray starts to move and
stop it there.
CAUTION:
Gear/L0, if turned counter clockwise continu-
ously, will mesh with the gear of the tray and
the tray will come out. When removing the
tray, use care so that gear/L0 will not mesh
with the gear of the tray.
c.
Pull out the tray ass’y.
4.
Removal of Table
a.
Remove 1 screw (
5
) and then remove the support/T.
(Fig. 1)
b.
Remove the plate/table. (Fig. 1)
c.
Remove 1 screw (
6
) and then take off the table.
(Fig. 1)
1
1
2
Table
Tray
6
4
5
3
Top cover
Plate/Table
Clamp ass'y
Support/T
Tray
Gear/L0
Front panel unit
Fig. 2
•
Precaution for installation of the Tray Ass’y.
On tray ass’y setting.
Check the direction of marking “
H
H
H
H
H
” on gear accord-
ing to this drawing.
Fig. A
Gear/L0
Front panel
Gear/L01
Marking
•
IMPORTANCE: Installation of Table.
Install the table according to the following procedure.
1) Slide the lever so that the gear/RT1 becomes
free. (Fig. B-1)
2) With the “
H
H
H
H
H
” mark on the gear/RT1 aligned with
the same mark on the tray, lock it with the lever.
(Fig.B-1)
3) Install the table by aligning it to the thick line on “
/
”
mark. (Fig. B-2)
* Check that the Table is locked after installa-
tion.
Fig. B-1
Fig. B-2
Lever
Gear/RT1
Fit the gear/RT1 to "
▲
" mark.
Lock
Unlock
Tray
Tray
Table
Fit the table to the thick line on "
/
" mark.
