18
1
Follow step 1, 4 and 5 on page 17.
2
3
If necessary, select the desired disc.
4
Select the desired track.
5
Repeat step 3–4 to set more programs for side A of
the tape. You can select the same track again.
* If “E rr” appears in the display, the track number just
selected cannot be programmed because there is not
enough time remaining on side A of the tape.
6
After you finish the programming for side A, program
the pause mode by pressing the TAPE button.
* “Pu” flashes in the display, and after then you can begin
programming for side B.
7
Follow step 3–4.
8
Repeat step 3–4 to set more programs for the side B
of the tape. You can select the same track again.
* If “E rr” a ppears in the display, the track number just
selected cannot be programmed because there is not
enough time remaining on side B of the tape.
9
The peak level searching function of this unit is useful
for adjusting recording level on the tape deck. For
peak level searching, when the programming for side
B is finished, press the PROG button and then press
the PEAK button.
10
Begin recording on the tape deck and press the
PLAY/PAUSE button on this unit at the same time.
11
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording
and, at the same time, press the PLAY/PAUSE
button on this unit.
Notes
●
If you will program tracks from more than one disc, before
you press the PROG button, check the total recorded time of
each disc on the disc tray by pressing the DISC SKIP button
in turn. Without this operation, the total remaining time of
each side of the tape and previously programmed track
numbers (and also unprogrammed track numbers) will not
be displayed during programming.
●
In step 5 and 8, even if “E rr” appears in the display, you can
program another track of which time is shorter than the
remaining time on the side of the tape. In this case, you can
check the remaining time on the side of the tape by pressing
the TIME display mode-select button.
●
CD synchronized recording method can be used if your tape
deck is compatible with it.
In this case, in step 10 and 11, press the SYNCHRO button
and then press the PLAY button on this unit’s remote control
transmitter. Recording automatically begins.
(For details, refer to page 21.)
Notes on tape programming
●
To check, cancel or correct program data, refer to page 13.
●
Up to a maximum of 40 tracks can be programmed from
among any or all of the five discs loaded on the disc tray. If,
however, the PAUSE mode is inserted, each PAUSE is
counted as one track.
●
This function can be used to program up to track number 20.
If the disc has more than 20 tracks, track number 21 and
thereafter will not be programmed.
■
Manual tape programming
This is for recording desired tracks selected from one or more discs in any desired order onto tape.
6
10, 11
3
2, 9
4
9
10, 11
3
6
2, 9
4
9
1
10
2
3
4
5
6
7
8
9
0
+
TAPE
PROG
DISC SKIP
Flashes on and off.
CDC-845
CDC-745
