Yamaha CDR-HD1500 Service Manual Download

Page: 4 / 62

CDR-HD1500

■

PREVENTION OF ELECTROSTATIC DISCHARGE

Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called
Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistors and
semiconductor “chip” components. The following techniques should be used to help reduce the incidence of component damage caused by
electro static discharge (ESD).
1. Immediately before handling any semiconductor component or semiconductor-equipped assembly, drain off any ESD on your body by

touching a known earth ground. Alternatively, obtain and wear a commercially available discharging ESD wrist strap, which should be
removed for potential shock reasons prior to applying power to the unit under test.

2. After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as aluminum foil, to

prevent electrostatic charge buildup or exposure of the assembly.

3. Use only a grounded-tip soldering iron to solder or unsolder ES devices.
4. Use only an anti-static solder removal device. Some solder removal devices not classified as “anti-static (ESD protected)” can generate

electrical charge sufficient to damage ES devices.

5. Do not use freon-propelled chemicals. These can generate electrical charges sufficient to damage ES devices.
6. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Most

replacement ES devices are packaged with leads electrically shorted together by conductive foam, aluminum foil or comparable
conductive material).

7. Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material to the

chassis or circuit assembly into which the device will be installed.
CAUTION: Be sure no power is applied to the chassis or circuit, and observe all other safety precautions.

8. Minimize bodily motions when handling unpackaged replacement ES devices. (Otherwise harmless motion such as the brushing

together of your clothes fabric or the lifting of your foot from a carpeted floor can generate static electricity (ESD) sufficient to damage an
ES device).

Grounding for electrostatic breakdown prevention

1. Human body grounding:

Use an anti static wrist strap to discharge the static electricity
from your body.

2. Work table grounding:

Put a grounded conductive material (sheet) or iron sheet on
the area where the optical pickup is placed.

Caution:

The static electricity of your clothes will not be grounded
through the wrist strap. So take care not to let your clothes
touch the optical pickup.

Ω

Conductive material
(sheet) or steel sheet

Anti-static wrist strap

VARO!:

A V A T T A E S S A   J A   S U O J A L U K I T U S
O H I T E T T A E S S A   O L E T   A L T T I I N A
N Ä K Y M Ä T T Ö M Ä L L E   L A S E R -
SÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.

VARNING!: O S Y N L I G L A S E R S T R Å L N I N G N Ä R

DENNA DEL ÄR ÖPPNAD OCH SPÄRREN
Ä R U R K O P P L A D . B E T R A K T A E J
STRÅLEN.

www. xiaoyu163. com

QQ 376315150

TEL 13942296513