14
USING THE BUILT-IN TIMER
Setting the clock
You must set the clock before you use the timer functions.
The clock is based on a 24-hour system.
1
While the power is on, press
DISPLAY
to display
the time.
2
While holding
TIME ADJ
, press
HOUR
to set the
hour.
•
If you want to move the time in the reverse
direction, press
HOUR
while holding
TIME ADJ
and
PRESET/BAND
.
3
While holding
TIME ADJ
, press
MIN
to set the
minutes.
•
If you want to move the time in the reverse
direction, press
MIN
while holding
TIME ADJ
and
PRESET/BAND
.
To display the clock
Press
DISPLAY
.
The current time appears for about 8 seconds, then the
normal display returns. Some buttons and controls may
not work while the current time is displayed.
Note
• In the event of a power failure or when the AC power cord is
disconnected for more than five minutes, you must reset the
clock.
Adjusting the brightness
of the display
You can adjust the brightness of the display. If you have
connected the CD player (CDX-E200), cassette deck
(KX-E100), and/or MD recorder (MDX-E100) to this
unit, the brightness of the displays is automatically
adjusted to that of this unit.
Press and hold
DISPLAY
for about two seconds so that
“Dimmer ±0” appears on the display. While holding
DISPLAY
, turn
INPUT
clockwise to increase or
counterclockwise to decrease brightness.
Control Range: ±0 to –6 (Preset value: ±0)
HOUR
DISPLAY
PRESET/BAND
TIME ADJ
MIN
INPUT
DISPLAY
STANDBY/ON
PHONES
DISPLAY
+
–
+
–
R
L
MEMORY
AUTO/MAN'L
TIME ADJ
TIMER
HOUR
MIN
BASS
TREBLE
BALANCE
MAX
MIN
VOLUME
INPUT
PRESET/TUNING
PRESET/BAND
NATURAL SOUND STEREO RECEIVER RX-E200
STANDBY
TIMER
STANDBY/ON
PHONES
DISPLAY
+
–
+
–
R
L
MEMORY
AUTO/MAN'L
TIME ADJ
TIMER
HOUR
MIN
BASS
TREBLE
BALANCE
MAX
MIN
VOLUME
INPUT
PRESET/TUNING
PRESET/BAND
NATURAL SOUND STEREO RECEIVER RX-E200
STANDBY
TIMER
08/14-16_RXE200(M).E
01.6.22, 8:51 PM
14
