Yamaha CL1 Reference Manual Download

Page: 219 / 277

Other functions

Reference Manual

219

■

When the setup method select button is SUPPORTED DEVICE

If you want to select and mount an I/O device that is supported by the CL series, press the SUPPORTED
DEVICE button to see the SUPPORTED DEVICE field. These settings can be made even when not
connected to a Dante audio network.

This screen contains the following items.

DEVICE TYPE

This area shows a list of the I/O device types that are supported by the CL series.
From the list, choose the type of I/O device that you want to mount.

DEVICE TYPE select knob

Use the multi-function knob to select the type of I/O device that you want to mount.

I/O device indication

This area shows the selected I/O device.
The upper line shows the front panel of the I/O device.
The lower line shows the model name and the number of inputs and outputs.

UNIT ID knob

Use the multifunction knobs to specify the UNIT ID.
The indicator shows the UNIT ID.

NOTE

• If there is one I/O device, set the I/O device’s UNIT ID to “1”.
• If multiple devices are connected, assign the ID numbers so that there is no conflict between

devices.

• For devices other than the Rio series, it is possible for devices of differing models to be assigned

to the same ID as an Rio series unit or the same ID as a different model of device. However since
the I/O device input/output port screen shows the UNIT ID, this will make it difficult to distinguish
between the units, so we recommend that whenever possible, you avoid allowing the ID numbers
to overlap.

• If you have a device whose UNIT ID or device label cannot be changed from its panel or its edit

screen etc. (such as the Dante-MY16-AUD card or DANTE-ACCEL), and you want to use that
device as a SUPPORTED DEVICE, you must change its device label via Dante Controller.

• The Dante-MY16-AUD and DANTE-ACCEL will be recognized as a SUPPORTED DEVICE if you

assign the device label as follows.

Dante-MY16-AUD:

Y###-Audinate-DANTE-MY16******

DANTE-ACCEL:

Y###-Yamaha-DANTE-ACCEL*******

# is a three-digit hexadecimal number containing the digits 0–9 and uppercase A–F (000–
FFF)
* indicates any desired character (alphabetical uppercase or lowercase, numerals, or -
(hyphen) may be used)

• If you are controlling the CL console from an Rio series unit, we recommend that you set the Rio

unit’s START UP MODE to “REFRESH.”
Operation will be safer with the “REFRESH” setting, since mute will be cleared after
synchronization has been completed with CL units whose system setting for REMOTE HA
ASSIGN is set to “WITH RECALL.”
With the “RESUME” setting, mute will be cleared and the unit will start operating with the settings
that were backed up by the Rio series unit itself, which could allow unexpected audio to be output.

• A single CL console can control the HA of up to eight Rio series units.

If nine or more Rio series units are connected, you can either divide the HA control between
multiple CL consoles, or you can omit specifying REMOTE HA ASSIGN for the Rio series units
whose HA does not need to be controlled, and use them with START UP MODE set to
“RESUME.”