13
CLP-970/CLP-970M/CLP-970C/CLP-970A/CLP-970AM/CLP-970AC
[9]
[3]
FDD Cover
Holder, FDD
(Fig. 15)
11
FDD Assembly
11-1
Remove the six [6] screws marked [83]. The FDD
assembly can then be removed. (See Fig. 15)
11-2
Remove the four [4] screws marked [9]. The FDD
cover can then be removed. (See Fig. 16)
11-3
Remove the four [4] screws marked [3]. The holder
FDD can then be removed. (See Fig. 16)
*
Model equipped with “A” has no floppy disk drive.
12
Back Board
Remove the two [2] screws marked [S2] and the
four [4] screws marked [S4]. The back board can
then be removed. (See Fig. 17)
13
Speaker
13-1
Remove the music rest assembly. (See procedure 1.)
13-2
Remove the keycover assembly. (See procedure 5.)
13-3
Remove the four [4] screws marked [4a]. The 13cm
speaker can then be removed. (See Fig. 18)
13-4
Remove the three [3] screws marked [4b]. The 2.5cm
speaker can then be removed. (See Fig. 18)
*
The left speaker and right speaker can be removed
in the same manner.
14
Main Unit
14-1
Remove the back board assembly. (See procedure 12.)
14-2
Disconnect the AC cord.
14-3
Disconnect the PK cable.
14-4
Remove the four [4] screws marked [S3]. Lift the
main unit up slightly and then slide it to backward
and then lift it up. (See Fig. 19)
*
Be sure to place your hands at least 15cm from
either end of the main unit and take care not to
pinch your fingers when removing it.
FDD Ass'y
[83]
[83]
[S4]
[S2]
Back Board
[4a]
[4b]
Speaker
Speaker
[S3] x 4
AC Cord
Bottom face of the Keybed
(Fig. 16)
(Fig. 18)
(Fig. 19)
[83]: Bind Head Tapping Screw-1 3.5X14 MFZN2BL (EP030250)
[3]: Bind Head Screw 3.0X5 MFZN2Y (EG330150)
[9]: PW Head Tapping Screw-B 3.0X8-8 MFZN2Y (V2276900)
[S2]: Truss Head Screw 4.0X12 MFZN2BL (VP367300)
[S4]: Truss Head Screw 4.0X20 MFZN2BL (03747290)
(Fig. 17)
[4]: PW Head Tapping Screw-1 4.0X16 MFZN2BL (EP040250)
[S3]: Truss Head Screw 6.0X25 MFZN2BL (VQ448400)