14
CLP-970/CLP-970M/CLP-970C/CLP-970A/CLP-970AM/CLP-970AC
[5]
Rack Assembly
PK Connector Assembly
Pedal Assembly
Pedal Box Assembly
(Fig. 20)
(Fig. 25)
(Fig. 26)
15
Rack Assembly
15-1
Remove the music rest assembly. (See procedure 1.)
15-2
Remove the speaker grille. (See procedure 2.)
15-3
Turn the speaker box assembly backwards and turn it up.
(See procedure 3.)
15-4
Remove the keycover assembly. (See procedure 5.)
15-5
Remove the panel assembly. (See procedure 6.)
15-6
Remove the GH keyboard assembly. (See procedure 9.)
15-7
Remove the four [4] screws marked [5]. The rack
assembly can then be removed. (See Fig. 20)
16
Remove the Speaker Box Assembly
(Hinge “A” Type)
16-1
Remove the music rest assembly. (See procedure 1.)
16-2
Remove the speaker grille. (See procedure 2.)
16-3
Turn the speaker box assembly backwards and turn it up.
(See procedure 3.)
16-4
Remove the six [6] screws marked [48h]. (Indi-
cated by the black arrows in Fig. 21)
16-5
Loosen three [3] screws [48i] (indicated by the
white arrows in Fig 21.) and then pull up the
speaker box assembly. (See Fig. 21)
*
Take care not to draw away three [3] screws [48i].
*
Prior to remove the speaker box assembly, disconnect
the connector from the NW circuit board, remove four
[4] screws [48j] to remove the cable assembly fastner.
(See Fig. 22)
[5]: Bind Head Tapping Screw-1 3.5X16 MFZN2Y (EP030190)
[7]: Bind Head Tapping Screw-1 4.0X14 MFZN2Y (EP040230)
*
When reinstalling, fit the notch of the hinge into the
loosened screws [48i] (See procedure 16-5), fix the
speaker box assembly with a stay, then tighten the
screws.
*
Make sure to follow this procedure only when
removing/refitting of the speaker box assembly is
required.
(Hinge “B” Type)
*
Hinge “B” Type has no notch for a screw. When
removing the speaker box assembly, hold the ass'y
from the backside as shown in Fig.23 to remove all
the screws [48h] and [48i]. (See Fig. 23 and 24.)
17
Pedal Assembly
17-1
Disconnect the PK cable. (See Fig. 25)
17-2
Place the back of the unit on a soft blanket.
17-3
Remove the eight [8] screws marked [7B]. The
pedal assembly can then be removed.
(See Fig. 26)
Type “A”
Type “B”
[48h]
[48i]
[48j]
[48j]
NW
(Fig. 21)
(Fig. 22)
(Fig. 23)
(Fig. 24)
[48]: Bind Head Tapping Screw-1 3.5X12 MFZN2BL (EP030340)
[48]: Bind Head Tapping Screw-1 3.5X12 MFZN2BL (EP030340)