CRX-M170
8
CRX-M170
Disc Table
Pick-up Head
Gear A
Sled Shaft
19.4
±
0.2mm
Stopper
Check that the disc table height is as specified below.
Fig. 7
Fig. 5
Fig. 6
Stopper
!1
Stopper Pin
!2
Sub Chassis (S)
!3
!3
Chucking Unit
Stopper
Hook
Drive Gear
Drive Unit
7. Removal of Pick-up Head
a. Remove 2 screws (
!2
). (Fig. 6)
b. Remove a pick-up cable. (Fig. 6)
c. Remove 4 screws (
!3
) and then remove the Drive
Unit. (Fig. 6)
d. Remove the gear A. (Fig. 7)
e. Pull out the Sled Shaft. (Fig. 7)
f. Remove the Pick-up Head.
6. Removal of Tray Unit
a. Remove 2 screws (
!1
) and then remove the
Chucking Unit. (Fig. 5)
b. Remove 1 hook and then remove the Stopper Pin.
(Fig. 5)
c. Rotate the Drive Gear and then open the Tray Unit.
(Fig. 5)
d. Detach the Stoppers on both sides and then pull out
the Tray. (Fig. 5)
Pick-up Cable
Summary of Contents for CRX-M170
Page 21: ...CRX M170 CRX M170 ...
