CXS series Owner’s Manual
9
Cardioid Mode Setup
Because directi
v
ity in the low frequency range is weak, the output sound from the su
b
woofer diffracts not only toward
the audience
b
ut also to the stage with almost the same sound pressure. By using the Cardioid mode,
b
ass to the
audience is summed up and
b
ass to the stage is canceled. This suppresses the
b
ass
v
olume on the stage, pro
v
iding
greater headroom
b
efore feed
b
ack, and resulting in more powerful
b
ass for the audience.
In order to setup the Cardioid mode, you should process the signals correctly using a processor. Also, the signals
from an amplifier to
b
oth FRONT and REAR are required. Visit the CXS product page of the Yamaha Pro Audio
glo
b
al we
b
site for details on the setting information of the processors for the CXS.
Using the [OUTPUT] jack along with a 4-pole speakON ca
b
le, you can connect the FRONT signal and REAR signal
from a 2-channel amplifier with a single ca
b
le.
Troubleshootin
g
If any specific problem should persist, please contact your Yamaha dealer.
Symptom
Possible causes
Possible solution
No sound.
The cable is not connected properly.
Connect the speakON cable to the [INPUT/PARAL-
LEL] jack correctly. Make sure to connect the amplifier
outputs to the 1+/1– contacts of the speakON cable.
Sound is inter-
rupted suddenly.
The built-in protection system has been
enabled because the input volume is exces-
sive.
To reset (cool down) the protection system, lower the
volume of the input device, or stop the input. Wait for
30 seconds or longer. If the unit doesn’t automatically
reset itself, there is a possibility of malfunction of the
speaker unit.
The speaker unit is damaged.
If no sound although the connection and signal level
are appropriate, there is a possibility of malfunction of
the speaker unit. Contact your Yamaha dealer.
The amplifier shuts
down.
When connecting the speakers in parallel, the
total impedance of the speakers is less than
the minimum load impedance of the amplifier.
(For example, when more than three eight-
ohm speakers are connected in parallel to an
amplifier having a minimum load impedance
of four ohms.)
Lower the number of speakers connected in parallel,
or use the amplifier which can drive with the total
impedance of the speakers, in order to not be less
than the minimum load impedance of the amplifier.
The protection system of the amplifier has
been enabled because the input volume is
excessive.
Wait until the amplifier cools down. Before using it
again, lower the input volume.
Sound is distorted.
Input volume is excessive.
Lower the volume of the input device so that the limit
indicator of the amplifier lights only occasionally.
2-channel amplifier
CXS
CARDIOID FRONT
CXS
CARDIOID REAR
1+/1–:
CARDIOID REAR
2+/2–:
CARDIOID REAR
1+/1–:
CARDIOID FRONT
OUTPUT
Routes the signals
received via 2+/2– to
1+/1– for output.
From
amplifier
To next CXS
4-pole speakON cable
Summary of Contents for CXS15XLF
Page 12: ...70 CXS series Owner s Manual ...
