DD-45/YDD-40 Owner’s Manual
9
Listening to the Demo Songs
This instrument features three demonstration Songs (
d1
–
d3
), specially created to show-
case the dynamic possibilities of the instrument.
1.
Turn on the power.
Turn down the volume by turning the [MASTER
VOLUME] control to the left and press the [
]
(Standby/On) switch to turn on the power.
A Drum Kit number is displayed after the “
dd
” indi-
cation, as the power is turned on.
Press the [
] (Standby/On) switch again to turn
the power off.
CAUTION
• Even when the instrument is turned off, electricity is still
flowing to the instrument at the minimum level. When you
are not using the instrument for a long time, make sure you
unplug the AC power adaptor from the wall AC outlet, and/
or remove the batteries from the instrument.
2.
Press the [DEMO] button to start a
Demo Song.
The indication “
d1
” appears on the display and the
provided Demo Songs start playing in succession
until you stop them.
While the Demo Song is playing, you can change to
the next or previous Demo Song by using the [
]
and [
] buttons. Pressing the [
] and [
] but-
tons simultaneously calls up the “
d1
” Song.
NOTE
• While a Demo Song is playing, available operations are limited
to adjusting the volume, changing the Demo Songs, and stop-
ping the demo.
3.
Press the [DEMO] button again to
stop the Demo Song.
You can also stop the Demo Song by pressing the
[START/STOP] button.
Auto Power Off function
To prevent unnecessary power consumption, this
instrument features an Auto Power Off function that
automatically turns the power off if the instrument is
not used—i.e., no buttons or pads are pressed—for
approximately 10 minutes.
NOTE
• Any settings, such as the Custom Kit (page 12), will be
restored to the factory default settings when the power is
turned off.
The Auto Power Off function can be disabled if you
turn the power on by holding the [
] (Standby/On)
switch for more than 3 seconds; the indication “
dd
”
blinks for a while.
Adjusting the volume
d1
Demo Song
number
Decreases the
overall volume.
Increases the
overall volume.
