12
DD-65/YDD-60 Owner’s Manual
Playing the Demo Song
The DD-65/YDD-60 features several demonstration songs (001–005), specially created
to show you the dynamic possibilities of the instrument.
1
Turn on the power.
2
Start the Demo Song.
3
Stop the Demo Song.
Turn on the
[STANDBY/ON]
switch on.
• Even when the switch is in the “STANDBY” position, electricity is still flowing to
the instrument at the minimum level. When you are not using the DD-65/YDD-60
for a long time, make sure you unplug the AC power adaptor from the wall AC
outlet, and/or remove the batteries from the instrument.
Press the
[DEMO]
button and the demo song starts playing.
To stop playback, press the
[DEMO]
button again or press the
[START/STOP]
button.
●
Adjusting the volume
Turn the
[MASTER VOLUME]
control.
●
SONG VOLUME
The SONG VOLUME can be used to adjust the balance
between the song accompaniment and your own perfor-
mance on the pads.
Enter the Function mode by pressing the
[FUNCTION]
button, then press the
[DRUM 1]
or
[DRUM 2]
button a
number of times until the “
SGL
” item appears. The current
Song volume appears when it is released.
To raise the value, turn the
DIAL
to the right (clockwise),
and to lower it, turn the
DIAL
to the left (counter-clock-
wise). Volume range is from 0 to 127.
Exit from the Function mode by pressing the
[FUNCTION]
button.
• The [DRUM 1] and [DRUM 2] buttons change the selected
order of the function item.
CAUTION
Decreases
the overall
volume.
Increases
the overall
volume.
SGL
NOTE
