Setting Up
DD-75 Owner’s Manual
13
Connecting Pedals 1 and 2
Connect the supplied Pedal 1 to the [PEDAL 1 (KICK)] jack
and Pedal 2 to the [PEDAL 2 (HI-HAT)] jack.
Turning the Power On/Off
1
Turn down the [MASTER VOLUME] dial to “MIN.”
2
Press the [
] (Standby/On) switch to turn the
power on.
The display lights up. Adjust the volume as desired
while striking the pads.
3
Press and hold the [
] (Standby/On) switch
for about a second to turn the power off.
Setting the Battery Type
Depending on the battery type to be used, you may need
to change the battery type setting on this instrument. To
change the setting, first turn on the power to the instru-
ment, then choose the battery type you would like to use.
Alkaline (and manganese) batteries are chosen by default.
1
Press the [FUNCTION] button.
Press the [DRUM 3] or [FUNCTION] button a number of
times until the “
btt
” item appears. The currently
selected battery type appears next to the “
btt
” indica-
tion.
2
Change the battery type by turning the dial.
To select Ni-MH, turn the dial to the right (clockwise)
until the “
n-H
” item appears, and to select Alkaline/
Manganese, turn the dial to the left (counter-clockwise)
until the “
ALn
” item appears.
3
Press the [FUNCTION] button to exit.
• Avoid getting caught in or tripping over the pedal cords;
this may cause the instrument to fall and result in damage
or injury.
• Avoid using the pedals directly on a soft floor, since they
may scratch the surface of the floor.
• Make sure that the pedal plugs are properly connected to the
PEDAL jacks before turning on the power.
• Do not press the pedals while turning the power on. Doing
this changes the recognized polarity of the pedal, resulting in
reversed pedal operation.
• You can use an Electronic drum pad KP65 (sold separately) or
an Electronic kick unit KU100 (sold separately) and hi-hat con-
troller HH65 or HH40 (sold separately) plugging into the
[PEDAL 1 (KICK)] jack and [PEDAL 2(HI-HAT)].
Pedal 1
Pedal 2
CAUTION
NOTICE
NOTE
When the power is turned on, Drum Kit number will
appear after the “
dd
” item appears. Drum Kit num-
ber “1” is normally selected.
• Even when the power switch is turned off, electricity is still
flowing to the product at the minimum level. When you are
not using the product for a long time, make sure to unplug
the power cord from the wall AC outlet.
• Do not attempt any other operations, such as pressing but-
tons or the pedal. Doing so may cause the instrument to
malfunction.
• Do not turn off the power while saving data (a “-” mark
appears and moves from left to right on the display). Doing
so can result in loss of data.
• Failure to set the appropriate battery type may shorten the
battery life. Make sure to set the battery type correctly.
CAUTION
NOTICE
NOTICE
Summary of Contents for DD-75
Page 58: ...DD 75 58 ...
