Setting Up
DD-75 Owner’s Manual
15
Using a Snare Drum Stand
This instrument can be installed on a snare drum stand (sold separately)
for convenience and ease in playing.
Snare drum stand (sold separately): SS662, SS740A
Setting Up
• Open the legs wide enough so that the snare drum stand is stable, but
not so much that the pipe touches the floor. Tighten the wing nut
E
.
• As shown in the illustration, make sure to always position the snare
drum stand so that one of the legs extends toward the player.
• Use wing nut
D
to adjust the height, and turn
B
so that it faces the
player.
• Use wing nut
C
to adjust the angle of
B
so that the instrument is
installed horizontally.
• Use rotary nut
A
to loosen the three arm basket to fit the three inden-
tations on the bottom of the instrument.
• Make sure all the nuts are securely tightened.
To install the snare drum stand
Put the arm covers into the indentations on the bottom of the instrument,
and tighten rotary nut
A
until the arms are secured. Make sure all the
nuts are securely tightened.
Be sure to handle the snare drum stand with care. Follow the important
precautions below. If not, the snare drum stand may overturn, causing the
instrument to drop and damage, possibly resulting in personal injury.
• Always place the snare drum stand on a flat, stable surface.
• Do not apply excessive force to the instrument.
• Do not adjust the height of snare drum stand with the instrument
installed.
• Remove the snare drum stand from the instrument before moving the
instrument.
• Do not use the snare drum stand other than designated ones (page 54).
A
C
Arms
Pipe
Legs
Snare drum stand
Player
B:
Faces the player
Keep horizontal
D
E
B
CAUTION
Summary of Contents for DD-75
Page 58: ...DD 75 58 ...
