Enhancing the Disklavier by Hooking Up Other Devices
10
Chapter
106
You can select the kind of the incoming/outgoing audio signals. The
following options should be set up in advance.
OMNI IN
Selects the appropriate option to match the incoming data input to the
OMNI (SYNC) IN jacks.
Auto Detect:
Select this to have the Disklavier detect the input signal
automatically.
Audio:
Select this when you play back audio from a connected CD
player, etc. and reproduce the sound from the monitor speaker.
OFF:
Select this when you cancel the data reception from the OMNI
(SYNC) IN jacks.
OMNI IN Vol
Adjust the volume of the incoming audio signals to the OMNI (SYNC) IN
jacks. The volume can be set in a range of 000 to 127.
OMNI OUT
Selects the desired data to be output from the OMNI (SYNC) OUT jacks.
Output:
Select this when you output the same audio signals as the
ones for the monitor speaker.
SYNC:
Select this when you output the SMPTE signal used for video
synchronization playback.
OFF:
Select this when you cancel the data transmission from the
OMNI (SYNC) OUT jacks.
OMNI OUT Vol
Note:
“M-Volume” is the next increment
on the OMNI OUT Vol setting
above 127.
Adjust the volume of the outgoing audio signals to the OMNI (SYNC) OUT
jacks. The volume can be set in a range of 000 to 127, or to “M-Volume.”
When you set to “M-Volume”, the OMNI OUT volume works with the main
volume.
ANALOG MIDI IN Vol
Adjust the volume of the incoming audio signals to the ANALOG MIDI IN
jacks. The volume can be set in a range of 000 to 127.
A-MIDI IN Offset
For some display devices, the video images may be displayed a little bit
later than the piano playing when playing back the video synchronized
software that contains the analog MIDI signal. To eliminate this delay, you
can adjust the offset time that leads the actual playback of the piano. A
delay is applied to the incoming analog MIDI signal. The offset time can be
set in a range of –500 ms to 0 ms. Decrease this value to delay the piano
playing, and increase to advance the piano playing.
Setting the Disklavier for Audio Data Reception/Transmission
[SETUP]
“AudioI/O”
000
127
M-Volume
OMNI OUT
Vol parameter
~
[–/NO]
[+/YES]
Summary of Contents for DISKLAVIER E3 CLASSIC
Page 1: ......
Page 11: ...English Classic Operation manual ...
Page 157: ...Appendix Classic Appendix ...
