3
Chapter
28
Playback can be started from a specified point in a song. Instead of using
fast forward or preview, you can use this function to go directly to a desired
point within a song.
If the current song uses the minutes and seconds time format, you specify
the point in minutes and seconds. If it uses the measures and beats time
format, you specify the point in measures and beats.
Press [SEARCH] on the remote control.
The song search screen appears with the counter flashing.
The song will be paused at the exact point as you press [SEARCH].
Note:
If you enter a value higher than the
entire song time, the search goes to
the end of the song.
Enter the time that you want to search for with the number
keypad.
For example, to search for 2:56 (minutes and seconds), first press
[0], then [2], [5], and [6].
For example, to search for 52-3 (measures and beats), first press
[0], then [5], [2], and [3].
Press [SEARCH] again.
The position of the song goes to the specified point.
Searching a Specific Section of a Song
During playback or stop/pause mode
[SEARCH]
1
=Memory=
<00:00>
0-9/SEARCH
A02-001
Flashes
2
=Memory=
<02:56>
0-9/SEARCH
A02-001
=Memory=
<052-3>
0-9/SEARCH
A02-001
3
Summary of Contents for DISKLAVIER E3 CLASSIC
Page 1: ......
Page 11: ...English Classic Operation manual ...
Page 157: ...Appendix Classic Appendix ...
