Yamaha DM3, Owner'S Manual

DM3 Owner’s Manual

11

Rear Panel

a

[OMNI OUT] Jacks

Has XLR-3-32 type output jacks for outputting analog 
audio signals. These jacks are primarily for outputting 
MIX channels and STEREO channels.

b

[INPUT] Jacks

For connecting to mikes and musical instruments.
1 to 12:

XLR-3-31 type input jacks

13 to 16: Combo jacks compatible with both XLR-type 
and TRS phone plugs.

c

Power Switch

In position ( l ), the power switch is ON.
In position (

z

), the power switch is on standby.

d

[DC INPUT] Connector

For connecting to the included power adaptor. First 
connect the product to the power adaptor and then 
insert the power plug into the outlet.

e

Dante PRIMARY/SECONDARY Connectors (DM3 
only)

These connectors are for Dante audio network 
connections, such as for I/O devices like the Tio1608-D. 
Use RJ-45 connectors that are compatible with Neutrik 
etherCON CAT5e.

NOTE

Do not use a network switching EEE function (*) within 
the Dante network.
The interactive power saving settings between switches 
compatible with the EEE function are adjusted 
automatically, but the interactive setting fails to adjust 
properly with some switches.
As a result, the EEE function may be enabled in 
inappropriate points in the Dante network, which can 
lead to poor clock synchronization and choppy audio.
So pay attention to the following points.
• If using a managed switch, turn OFF the EEE function 

of all ports that use Dante. Do not use switches 
whose EEE function cannot be turned OFF. 

• Do not use switches compatible with the EEE function 

when using a managed switch. The EEE function of 
these switches cannot be turned OFF.

d

c

e

a

b

g

f

NOTICE

• The power switch goes to standby at least 10 

seconds after the last operation. The product saves 
the state immediately before going into standby, and 
reproduces it when the power is back on.

• Let at least 6 seconds elapse after the power switch 

goes into standby before turning it back ON. 
Constantly turning the power switch ON/OFF may 
result in malfunction.

 WARNING

Only ever use the included cord as the power cord. 
Also, never use the included power cord for another 
product. Doing so may result in failure, overheating 
and/or fire.

 CAUTION

• Always put the power switch on standby before 

connecting or disconnecting the power cord.

• A small amount of power flows even when the 

power is OFF (on standby). When the product will 
not be used for a long time, always unplug the 
power cord from the outlet.

NOTICE

To prevent electromagnetic interference, use an STP 
(Shielded Twisted Pair) cable. Make sure that the 
metal parts of the plugs are electrically connected to 
the STP cable shield by conductive tape or 
comparable means.