DME Setup Manual
19
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
DME64N/24N Network Setup via Panel Operation
DME64N and DME24N device group and IP address settings can be made directly via the device’s panel.
1
Turn on the DME64N/24N power.
2
Press the [HOME] key to display the main
screen.
3
Press and hold the [UTILITY] key for more than 2
seconds to display the Utility screen.
4
Press the [UTILITY] a few times until the Net
page appears.
5
Use the [
▲
] and [
▼
] keys to move the cursor to
the parameters listed below and press the
[ENTER] key.
The corresponding editing dialog will appear. Make the
settings indicated for each parameter below, and press
the [ENTER] key each time to confirm and enter the
settings.
1
Master/Slave
Selects Device Group Master or Slave status.
Master:
One device must be assigned as the Master in
each Device Group.
Slave:
All other DME devices in the group should be set
to Slave.
n
When DME64N/24N and DME Satellite units are
combined in a Device Group, be sure to assign a DME
Satellite unit as the group Master.
2
IP Address
Set the IP addresses of the DME devices. All DME
devices in the same Device Group must be set to the
same network address.
n
When only one DME device (Master) is used, set the IP
address to “192.168.0.2”.
n
The subnet mask is fixed at “255.255.255.0”.
n
The host address can be set from 2 to 253 for the Master
device, and from 3 to 253 for Slaves.
n
Always use a private address (192.168.0.2. through
192.168.255.253) unless it is absolutely necessary to
use a global address. Consult with the network
administrator if it is necessary t use a global address.
3
Master ID
When a device is assigned as a Slave in Master/Slave
(
1
) above, this sets the host address for the Master
device in that group. This parameter cannot be set for the
Master device.
4
Link Mode
Make sure that “100Base-TX” is selected.
Appendix
1
2
3
4
Network address
Host address
