DME Setup Manual
14
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Going Online
After connecting the computer to the DME devices and going online, you can transfer configurations created using
the DME Designer application to the DME devices. The DME devices and DME Designer are “online” when they
are connected and able to communicate with each other. DME devices can also be controlled in real-time when
online.
1
Connect the DME devices to the computer as described on
, and turn the DME power on.
2
Launch the DME Designer application, select the [Open] command from the main panel [File] menu, and
open the previously saved project file.
n
The DME Designer can also be launched and the project file automatically loaded by simply double-clicking the project file icon.
3
Click the MIDI Setup button to open the MIDI dialog box.
n
If the DME ports are not displayed, check that the DME power is on and re-launch the DME Designer application.
4
Select the input and output ports to be used to control the Device Group Master, then click [OK].
When connected via USB select “YAMAHA USB IN 0-1” or “Yamaha DME NETWORK-1”, and “YAMAHA USB OUT 0-1” or
“Yamaha DME NETWORK-1”, and when connected via Ethernet select the device name specified via the DME-N Network
Driver (
5
Select the [Port] item from the main panel window [Setup] menu to open the Port dialog box.
6
Select the output and input ports specified in step 4 in the [Tx] and [Rx] fields, and the appropriate
Device Group in the [Device Group] field, then click [OK].
