If your computer is being used
within, for example, an office and
already has an IP address, either
the current setting can be
transcribed or you can connected it
to the Group Master using a USB
cable in order to perform setting.
Note
1. Installing the Software
4. In-depth information
on DME Units
3. Advanced Setup
(via Ethernet cables)
2. Basic Setup
(via USB cable)
Appendix: Detailed
DME-N Network Driver Settings
10
3-4.
Setting the DME-N Network Driver
Select "Additional Options" from the Control Panel.
3-3.
Connecting DME units to the network switch
When the required settings have been made, connect all DME units
and the computer to the switch using Ethernet cables.
At this point, the network should be setup in the same way as shown in
the Device Group diagram on page 08.
Select "Advanced Settings".
Computer
3-2.
Changing the computer's IP address settings
Open the Control Panel, and then select "View network status and tasks".
DME4io-C
DME8o-C
DME64N
Switch
USB
