8
PCY95AT
Owner’s Manual
As shown in the figures, set up your cymbal pad on an electronic drum rack.
Attaching the cymbal holder
1.
Take the cymbal holder from the package and loosen the clamp bolt. (See Figure 1.)
2.
Slide the holder clamp onto the electronic drum rack as shown by the arrow below. (See Figure 2.)
3.
Tighten the clamp bolt to secure the cymbal holder in place.
Setting Up
CAUTION
• If this product is used with a Rack System or Cymbal Stand, make sure all bolts are tightened
firmly. Also, when adjusting the height or angle, do not suddenly loosen the bolts. Loose bolts
may result in the rack overturning or parts dropping, causing injury.
• Do not place the product in an unstable position where it might accidentally fall over.
Clamp bolt
Cymbal holder
Holder clamp
Figure 1
Figure 2
