Setting Parameters using Menu Mode
DTX400K/DTX430K/DTX450K Owner’s Manual
52
6-7. Pad Gate Group
Using the following procedure, you can set which groups of
pads the drum module should consider when deciding
whether or not you are playing the correct pattern in Pad
Gate training (page 37).
1.
While holding the
[KIT]
button, press the
[SONG]
but-
ton to activate Menu Mode.
2.
Press number button
[6]
to select the Training Settings
parameter group.
3.
Press number button
[7]
to select the Pad Gate Group
parameter.
4.
Select a new setting using the corresponding number
button (
[1]
to
[4]
). The available settings are as follows.
6-8. Fast Blast Timer
Using the following procedure, you can set the timer for
Fast Blast training sessions (page 39). When the timer
counts down to zero after the start of a training session, it
will automatically end the training.
1.
While holding the
[KIT]
button, press the
[SONG]
but-
ton to activate Menu Mode.
2.
Press number button
[6]
to select the Training Settings
parameter group.
3.
Press number button
[8]
to select the Fast Blast Timer
parameter.
4.
Select your preferred practice time using the corre-
sponding number button (
[1]
to
[10/0]
). The available
settings are as follows.
Steps:
MENU ([KIT] + [SONG])
[6]
[7]
Setting
Number
button
Setting
Description
[1]
All pads
Any pad will produce a sound
and be scored, as long as the
timing of your drumming is
correct.
[2]
Group type 1
The kit will be separated into
five groups—Kick, Snare,
Toms, Cymbals, and Hi-hat. In
order for your drumming to
produce sounds and be
scored, you must strike pads
from the same group as those
from the practice drum pattern
and do so in time.
[3]
Group type 2
More difficult than Group type
1, this setting splits each of the
toms and each of the cymbals
into individual groups. In addi-
tion, the hi-hat pad and the hi-
hat controller are also treated
separately.
[4]
All notes
With this setting, you must play
the exact same practice drum
pattern as the drum module.
• The evaluation method set using this parameter applies only to
Pad Gate training. Other types of training are not affected.
• The higher the setting, the more difficult the training.
Setting
NOTE
Steps:
MENU ([KIT] + [SONG])
[6]
[8]
Setting
Number button
Setting
[1]
10 seconds
[2]
30 seconds
[3]
60 seconds
[4]
90 seconds
[5]
120 seconds
[6]
150 seconds
[7]
180 seconds
[8]
300 seconds
[9]
480 seconds
[10/0]
600 seconds
The timer set using this parameter applies only to Fast Blast train-
ing. Other types of training are not affected.
Setting
NOTE
