Setting Parameters using Menu Mode
44
Advanced Techniques
DTX402K DTX432K DTX452K Owner’s Manual
2-3. Pad Tuning
You can adjust the panning of the current kit’s pads.
1.
Hold down the
Mode switch
to activate Menu Mode.
2.
Press
number button [2]
to select the Kit Settings
parameter group.
3.
Press
number button [3]
to select the Pad Panning
parameter.
4.
Strike a pad to select it.
5.
Enter a new tuning setting using the
TEMPO[+]/[–]
buttons
in 25 cent steps. The “cent” is a unit of measure
for musical intervals. 100 cents make up a semitone. A
value of 64 corresponds to normal pitch (0 cents).
2-4. Double Bass Drum
You can easily configure the drum module to produce a kick
drum sound when you operate the pedal connected to the
[HI-HAT CONTROL]
trigger input jack. This convenient
function provides support for double bass drumming tech-
niques.
1.
Hold down the
Mode switch
to activate Menu Mode.
2.
Press
number button [2]
to select the Kit Settings
parameter group.
3.
Press
number button [4]
to select the Double Bass
Drum parameter.
4.
Set the parameter using
number button [1]
or
[2]
. The
available settings are as follows.
2-5. Reverb
Reverb effects add a warm ambience to sounds, simulating
the complex reflections of actual performance spaces, such
as a concert hall or a small club. Use the following proce-
dure to select a reverb effect for the current kit.
1.
Hold down the
Mode switch
to activate Menu Mode.
2.
Press
number button [2]
to select the Kit Settings
parameter group.
3.
Press
number button [5]
to select the Reverb parame-
ter.
4.
Select a reverb effect using the corresponding
number
button [1] to [10]
.
Steps:
Hold down the Mode switch
[2]
[3]
Setting
Setting
16 (-1200 cents) to 64 (0 cent) to 112 (+1200 cents)
Steps:
Hold down the Mode switch
[2]
[4]
Setting
Setting
Setting
Number button
Setting
[1]
Off
[2]
On
• While the Double Bass Drum function is enabled, you will be
unable to use the hi-hat controller plugged into the [HI-HAT
CONTROL] trigger input jack to simulate opening and closing of
the hi-hat.
• If using an HH40 Hi-hat Controller, you can adjust the kick veloc-
ity. For details, see 4-5. Kick Velocity (page 47).
Steps:
Hold down the Mode switch
[2]
[5]
Setting
Number button
Setting
[1]
Off
[2]
Hall
[3]
Studio
[4]
Room 1
[5]
Room 2
[6]
Stage
[7]
Small Stage
[8]
Plate
[9]
Early Reflection
[10]
Gate Reverb
NOTE
Setting
