DTX700 Reference Manual
15
KIT
: The current kit number is reduced by 1.
: The current kit number is increased by 1.
: The current kit number is locked.
NOTE
•
If you hold down the [SHIFT] button and press the [F1] or [F2]
button, the current kit number will be reduced or increased in
units of 10.
•
See
for details regarding cursor operations on Menu
area pages.
KIT/COMMON
List of Functions
Volume
Use this parameter to set the volume of the entire kit.
Settings:
0 to 127
NOTE
•
If you change the Volume parameter setting for MIDI channel
10 on the Menu area’s Kit/MIDI/Other page, the Volume
parameter on this page will be automatically set to the same
value. The reverse does not apply, however – in other words,
the Volume parameter for MIDI channel 10 from the Menu
area’s Kit/MIDI/Other page is not affected by changes made on
this page.
Tempo
Use this parameter to specify the tempo to be set automatically
upon selection of the current drum kit. An “off” setting means
that the tempo will not change automatically when the current kit
is selected – in other words, the tempo of the previously selected
kit is maintained.
Settings:
off, 30 to 300
NOTE
•
If waves are assigned to any of the kit’s pads, the tempo (or
speed) at which they are played will not be affected by the kit’s
tempo setting.
Trigger Setup Link (TrgSetupLink)
Use this parameter to specify the trigger setup to be used when
the current kit is selected. A trigger setup can be assigned to each
different drum kit. Select “off” if the currently selected drum kit
does not need a special trigger setup.
Settings:
off, 1 to 20
Name
Use this parameter to set a name for the currently-selected kit. A
name of up to 12 characters in length can be assigned to drum
kits.
Setting a Kit Name
1.
Press the dial to call up the kit naming page.
2.
Move the cursor within the name field using the [F1] and
[F3] buttons and select a character for that position by
turning the dial or pressing the [-/DEC] and [+/INC] but-
tons. The following characters can be used.
NOTE
•
If you hold down the [SHIFT] button and press the [F1]
or [F3] button, the cursor will move to the start or end of
the kit name field.
•
If you hold down the [SHIFT] button and press the [-/
DEC] or [+/INC] button, or alternatively, hold down the
[SHIFT] button and turn the dial, the cursor will jump
between the “
”, “0”, “A”, “a”, and “~” characters.
3.
When you have entered the required name, press the dial
or the [EXIT] button to return to the previous page.
4.
Press the [STORE] button and the dial to store your new
setting.
For settings affecting entire kits
KIT/COMMON
